but which is the right amount? i would think i should mark time 0 (direct signal) until the signal reaches -60dB (RT60), which would be logical for me to measure RT60 over all frequencies. How much of the the Impulse response should i mark? every time i move the bounderies of the impuls, the waterfall changes drastically, which is obvious. RT60 and the waterfall diagram dont correspond at all!!ģ. on the waterfall diagram i see reverberation though. for instance at Hz i get reverberation of 0ms. i used the minimum phase function and used the RT60, RT30 but they give me odd information. I would like to compare the reverberation times of my studio rooms to others, but i just dont know how. is there any way to measure the reverberation time in fuzzmeasure? i would like to have an RT60 over all frequencies (so just one time instead of for all frequencies). but if i move the loudspeaker slighty, i get a totally different frequency response, therefore there must be some room influence happening here also! im pretty confused here, to say the leastĢ. what does the frequency response really show me? is it the direct signal from loudspeaker to mic? or is it an average? it seems to be the same frequency response as the time 0 on the waterfall diagramm, so i would think its the direct signal. There are a few things in fuzzmeasure i still cant grasp and would appreciate a little help from you guys!ġ. Im finalizing the paper now and it has to be done very soon, so i hope i can get some help here. I am writing a diploma thesis about acoustics and acoustical measurements at the moment and am using Fuzzmeasure to measure different rooms and test acoustical treatments. so i decided to come here and see if someone can help me.Ī few quesions about frequency, reverberation and waterfall I Have asked this question over at the Fuzzmeasure Support site, but have not gotten any replies yet.

Fuzzmeasure user guide